So like BFL's issue here we grow again....lol.
Upon my ah test the PD charged the batts 2x's button pressed for 14.4v. I only checked amps once and were down to 10amps in. This was early on...
https://forums.goodsamclub.com/index.cfm/fuseaction/thread/tid/29599380.cfmThis morning in 13.6 mode and .5 amps going in. SG readings dead center of 1.225 and 1.250...
WTF is the issue here? Lag? I would think not??? Cant be sulfation as I thought I took care of that already..
Im no batt expert but something is wrong.
I do know one cell tests low SG in one batt. But if a cell was going bad wouldn't that cause higher amps in???
Now if I was in a boondocking situation, then the PD, generator running to its hearts content, solar etc, will not recharge these batts to 90%.
Unless the 90% is 1.240 sg.
The batts been on the PD for 17 hours....
I have since pulled out the sears charger once again...
It may be time to deep 6 these batts... But I am not sure...