Adjusting Slideout
In another thread, I mentioned that I'm replacing all of my seals around my slideout. While inspecting the slideout itself, I noticed that it's out of adjustment so I'll be doing that as well. Probabl...
Forum Discussion
Just a quick update. I adjusted my slide out and it works much better now. Still a squeal when going in or out over the hump but not as loud as it was. Other than that it's operating as it should. I was only able to raise the right side The left side would not drop down even though there was plenty of travel for it to go down so all adjustments were done from the one side. I then did a slight horizontal adjustment to make it even on both sides. Overall, I'm happy with how it turned out. I also put the new seals on. Much easier than I thought it would be. The hardest part was cleaning the old double sided tape that was left behind from the old seals. I used lighter fluid on a rag and it came off without too much elbow grease.
