Altitude compensator,,,

Please elaborate preferably with defining photo images.

I will try and post a couple pictures of the thing,,,

Look around under the hood. There should be a plug-in connector with 2 wires, that plugs into the android valve. It is nothing more than a potentiometer, that sends a signal to the ECM, that adjusts timing according to altitude. I removed the android valve from my old class C and added a manual potentiometer under the dash, so I could adjust the timing manually.
It's been too many years since I did that. I don't remember where the connector is.
Or are you talking about the valve that goes on the back of the carburetor?

Richard

Its a thing mounted next to battery on the right side, I think it has 3 wire plugs, I think 4 valves or solenoids and about 4 hoses going to it. I have pictures of it but cant figure out how to post them om here.

that didn't work

I cant figure out how to post pictures

Image posting thread. The thread is stickied in the DIY section of the Forum.

77Casual wrote:

Ah ha. You removed more than just the altitude sensor.
The device in the very bottom of the picture is the sensor.
There is a gentleman (subford) on IRV2 that is very knowledgeable of all thing Ford. I suspect he may be able to offer the help you seek.

Richard