am i missing something? 2016 onan generator on raptor

Loose wire somewhere.

As a first attempt, with the power OFF, open the transfer switch and make sure everything is tight.

How long are you waiting? It takes my Onan about 30 seconds to output AC power.

Is the RV new? Call the nearest Onan dealer. They will repair it under warranty.

all the wires are tight.

only thing i could think was it was wired backwards from the factory? when i run the generator, if i take a multi meter onto the shore power plug, i get 120v. is that normal?

brand new wyo. two weeks old, and not camped in yet. i also had a bad crimp on my leveling jacks which faulted the control display panel not to work, after 2 hours of trouble shooting i found it.

purchased from camping world. they advised me to bring it back for service. first available appointment is 2 weeks, and estimated time to get it fixed with "warranty authorizations" is typically another 2 weeks.

trying to have this all set for our first trip this weekend.

Are you saying the prongs on the male plug that would connect to a campground pedestal outlet go HOT when you start the genset and the transfer switch kicks in??? If so, then YES, transfer is wired wrong and that would mean

1. a VERY dangerous condition, and

2. no power transferred from generator output to you coach's 120VAC circuits

With a transfer switch wiring diagram, a meter, a helper and a cool head, you could correct the wiring BUT BUT BUT If the condition's as I understand it above, you are approaching very serious safety issues. Please don't attempt to correct this without gold plated double locking sure fire certainty that you can get it 1,000-percent right.

j-d. its my first camper, and i just wanted to re-assure myself.

i am a licensed electrician, and i do realize the severity of having two sources of power connected.

im just baffled that it would come from the factory like this? i was hoping i was missing something, perhaps another manual selector switch?

also,i did not want to alter my warranty, in order to correct the problem, the wires need to bugged in the box adjacent to the ats. unfortunately there is NO slack behind the wall in the romex, and its not long enough to swap the upper terminals to the lower on the one romex..

the last thing i wanted to do was have another problem down the road and not be covered because i re-wired the ats.

Certainly sounds like the ATS is wired wrong.

If you are familiar with 120 VAC, open it up and look.

Pretty simple: two feeds in (shore power and generator) one feed out (to RV 120 VAC breaker box).

If you are running the Genny with active power to the ats it will go into a safety lockout.

WyoTraveler wrote:
Is the RV new? Call the nearest Onan dealer. They will repair it under warranty.

It's not a generator issue.