Another AGM conditioning question
This is my chassis battery, an agm I got used and have little experience with. Trickle charger failed in storage, it is dead as a doornail. Not covenient to babysit it for long hours on meanwell or...
Forum Discussion
BFL13, LY, MW - Thanks again~!
And BFL13. Pretty good assumption you understand, it's me that does not do a 'Duh!' how can this be 12.7V 30 mins after be 12.7V? You know 'It's not you, it's me...'.
Watching temps via ARC-50 Magnum Temp Sensor, which is very close to the battery Infrared Temp readings. I did the posts, I'll do some scanning where I believe the Cell's should be, to see if temps vary on a specific battery cell.
If the battery temps look good, I'll continue the 14.4V... Now 1.5 hours into the second cycle of 4 hours. Still holding 15A:)!
Side question. I validated that the 9" Interconnects are #3 welding wire. That passes my filters, but I've proven I've been wrong before. His that an appropriate gauge of wire for 6V 400A connections?
Best,
Smitty
And BFL13. Pretty good assumption you understand, it's me that does not do a 'Duh!' how can this be 12.7V 30 mins after be 12.7V? You know 'It's not you, it's me...'.
Watching temps via ARC-50 Magnum Temp Sensor, which is very close to the battery Infrared Temp readings. I did the posts, I'll do some scanning where I believe the Cell's should be, to see if temps vary on a specific battery cell.
If the battery temps look good, I'll continue the 14.4V... Now 1.5 hours into the second cycle of 4 hours. Still holding 15A:)!
Side question. I validated that the 9" Interconnects are #3 welding wire. That passes my filters, but I've proven I've been wrong before. His that an appropriate gauge of wire for 6V 400A connections?
Best,
Smitty
