Did you ground your PD 9200 series converter?
I recently installed a new PD9260C deck mount converter in my fifth wheel. It did not come with anything resembling installation instructions, but it did have this schematic: The converter A...
Forum Discussion
Article 551.20 (C) of the NEC requires that the chassis of the converter be bonded to the vehicle frame with at least a #8 copper wire. This must be a non-current carrying wire.
The problem with depending on the 3 wire power cord is a fault within the converter could draw far more current than the power cord wire size could handle.
The problem with depending on the 3 wire power cord is a fault within the converter could draw far more current than the power cord wire size could handle.
