Does my 6v have a bad internal connection?
These are brand new 6v connected in series. Im cycling them in the garage using a 3.5a light bulb load. I had an RvWhisper batt monitor installed and noticed it was reading super low at 12.05v. ...
Forum Discussion
Note if that meter is the one I think it is the accuracy is not as good as say a Top End FLuke (or even a top end Radio Shack for that matter) so 12.5 MIGHT really be 12.7... I do have calibration instructions lying around and have calibrated a few meters.. but never that one.
With out a nut on the bolt tightened down a difference in voltage is. .actually expected. Put a lug on, a nut and tighten then re-measure.
With out a nut on the bolt tightened down a difference in voltage is. .actually expected. Put a lug on, a nut and tighten then re-measure.
