Does my 6v have a bad internal connection?
These are brand new 6v connected in series. Im cycling them in the garage using a 3.5a light bulb load. I had an RvWhisper batt monitor installed and noticed it was reading super low at 12.05v. ...
Forum Discussion
What is the make/model of your battery charger?
You need to get the proper battery charging specs for your batteries and then try and determine if that H.F. charger will properly charge your batteries.
My Xantrex Freedom charging configuration for wet cell batteries will NOT fully charge my four Interstate batteries. I checked them with a battery hydrometer after the Xantrex went to float. Not fully charged!
Got the proper charge specs from Interstate and punched them into my charge controller and now my batteries show charged using hydrometer.
The main issue was the adsorb voltage, not high enough on the Xantrex!
If I had a $ for every RV that was improperly charging their house batteries id be driving around in a Tesla!
You need to get the proper battery charging specs for your batteries and then try and determine if that H.F. charger will properly charge your batteries.
My Xantrex Freedom charging configuration for wet cell batteries will NOT fully charge my four Interstate batteries. I checked them with a battery hydrometer after the Xantrex went to float. Not fully charged!
Got the proper charge specs from Interstate and punched them into my charge controller and now my batteries show charged using hydrometer.
The main issue was the adsorb voltage, not high enough on the Xantrex!
If I had a $ for every RV that was improperly charging their house batteries id be driving around in a Tesla!
