Dometic Refer Too Cold
A six year old, three way, model 2652 is too cold. -5 in the freezer, 28 on the top shelf and 30 degrees on the bottom shelf, these temps are regardless of the position of the thermistor on the cooli...
Forum Discussion
The thermistor was replaced with OEM from Dometic.
It is on the far right fin, and protruding .5" above the clip.
The temps are taken with an infrared sensor, and cups of water are in the three locations.
It appears that I'm looking at replacing the board. Is the lower board the same as the control board that has been referred to?
For the potential replacement board, should I use OEM or Dinosaur?
Besides testing the new thermistor, checking the ohms, is there anything else I should test?
It is on the far right fin, and protruding .5" above the clip.
The temps are taken with an infrared sensor, and cups of water are in the three locations.
It appears that I'm looking at replacing the board. Is the lower board the same as the control board that has been referred to?
For the potential replacement board, should I use OEM or Dinosaur?
Besides testing the new thermistor, checking the ohms, is there anything else I should test?
