Engine Computer Connector
My ECM has 2 connectors, a 14 way connector and a 60 way connector. The 14 way connector was compromised by techs prior to, or early in my ownership, probing the wire insulation. Eventually wire...
Forum Discussion
Hmm, I just opened up my original ECM for a better look. One of the Pins is very loose and I can see it wiggling on the base of the circuit board through the clear potting.
The Potting is a bit discolored around this pin, and a few others that are still seemingly tight.
Perhaps all that is wrong with this original failed ecm, is the same thing, this 14 way connector base.
The wire broke off this connector before i wound up replacing the ECM for a No start or stutter after start condition. I thought it had failed because a transmission wire was shorted to ground, but I guess there can be more than one reason.
The Potting is a bit discolored around this pin, and a few others that are still seemingly tight.
Perhaps all that is wrong with this original failed ecm, is the same thing, this 14 way connector base.
The wire broke off this connector before i wound up replacing the ECM for a No start or stutter after start condition. I thought it had failed because a transmission wire was shorted to ground, but I guess there can be more than one reason.
