Engine Computer Connector
My ECM has 2 connectors, a 14 way connector and a 60 way connector. The 14 way connector was compromised by techs prior to, or early in my ownership, probing the wire insulation. Eventually wire...
Forum Discussion
Sarcasm alert:
Egad!! You cantankerous curmudgeon of a fuddy duddy know it all!!!
:)
Did you ever consider that perhaps I was looking beyond just this particular task?
Also,
How about the smallest bottle of "shield" available is 25+ dollars
The smallest tube of D100 is $9.99 and comes in the kit
So if I were to order just these two recommended products by themselves, I would spend 7+$ more, and would not get that oh so covetable storage Box that comes with the Kit!!!!
I'm gonna cover it in glitter.:R
Not to mention the Deoxit gold!! In both spray form and concentrate!!
And don't get me started on the wipes!!!
All kidding aside, I was impressed with all the information Caig provides online, and I thought the Kit was a neat job of marketing and packaging for which I wished to reward them.
http://store.caig.com/s.nl/sc.18/category.236/.f
I can get a q tip down around those pins, but I gots to remove a bit of cotton, or get the super inexpensive q tips from the 99 cent store whose thin plastic stems are too weak to effectively remove itch inducing wax from my outer ear.
---
Mex, are you saying if I were somehow able to get the d100 back behind the connector, so that it infiltrated the circuit board/Pin solder joint My issues would disappear?
The connector base in the photo shown on page one, is about 3/8 to half an inch away from the circuit board, through the potting. I seriously doubt the d100 could creep that length through those obstacles.
I'm not going to trust it, until the broken solder joints, are solid again.
Egad!! You cantankerous curmudgeon of a fuddy duddy know it all!!!
:)
Did you ever consider that perhaps I was looking beyond just this particular task?
Also,
How about the smallest bottle of "shield" available is 25+ dollars
The smallest tube of D100 is $9.99 and comes in the kit
So if I were to order just these two recommended products by themselves, I would spend 7+$ more, and would not get that oh so covetable storage Box that comes with the Kit!!!!
I'm gonna cover it in glitter.:R
Not to mention the Deoxit gold!! In both spray form and concentrate!!
And don't get me started on the wipes!!!
All kidding aside, I was impressed with all the information Caig provides online, and I thought the Kit was a neat job of marketing and packaging for which I wished to reward them.
http://store.caig.com/s.nl/sc.18/category.236/.f
I can get a q tip down around those pins, but I gots to remove a bit of cotton, or get the super inexpensive q tips from the 99 cent store whose thin plastic stems are too weak to effectively remove itch inducing wax from my outer ear.
---
Mex, are you saying if I were somehow able to get the d100 back behind the connector, so that it infiltrated the circuit board/Pin solder joint My issues would disappear?
The connector base in the photo shown on page one, is about 3/8 to half an inch away from the circuit board, through the potting. I seriously doubt the d100 could creep that length through those obstacles.
I'm not going to trust it, until the broken solder joints, are solid again.
