Furnace problems
My furnace has never worked since I bought it new. so far we have spent over $750 to get it working and it has been reimbursed by the manufacturer, but I doubt they will offer to spend much more. We...
Forum Discussion
wa8yxm wrote:Toddupton wrote:
Have you completely bypassed the thermostat?
His post indicates that is NOT the problem
To the O/P. I am assuming it tries to fire 3 times then shuts down. If so check the curcuit board for a LED that should be flashing 3 times
I do not now the particulars of YOUR furnace but if you are in S.E. Ga I'm 3 miles off I-95 and can take a look at it.. I had a problem like that with mine (Mine was the circuit board) and learned far more than I wanted to about RV furnaces tribble shooting..
Here is a bit of info:
There are basically two types.
One has a single "probe" that is both the flame sensor and one of the ignition points.. IF it is lighting the ignition part is working
The other has two probes, one ignition (often the gap is too wide) and one Flame Sensor.
If you have the first, Circuit board problems are a major feature of that design..... but there is a cure.
Tad late to the party..
OP posted EARLY this AM what issue was and that it was FIXED :S
