If it is OK to start generator in eco mode I would be good with that and that would solve a lot of issues. I have forgotten it was in eco mode and have started the gen with no problem. I always have everything in the RV turned off before I ever start the gen. Even when it's running, I don't use two large draw systems at the same time. Such as, if I'm going to use microwave I turn off A/C. I don't even use electric water heater at same time as A/C.
I am confused by the "overload" malfunction when I am in full throttle mode and turn on AC.
Follow up:
I have now been running gen in eco mode and A/C for several hours. The gen is cycling from 2650 RPMs to 3050 RPMs as the A/C compressor cuts in and out. Everything is working fine but I had to go back and test again. Now I'm really confused:
The A/C was running as described and compressor was in off cycle. I switched gen from eco mode to full throttle mode and when A/C compressor came back on, nothing happened. Gen continued to run at full throttle and did not speed up and A/C (and everything in RV) stayed on. Gen did not go into overload.
It is very hard to figure this one out ??? I think I have a ghost in either my RV or my gen that is messing with me.
Original poster