Generator break in procedure
Does anyone know if there is a correct procedure to break in a new generator? ie let it idle for so long then put it under a load for so long ?
Forum Discussion
The following is from my new Champ 2K model 100565 owner's manual.
The first 5 hours of run time are the break-in period for the
unit. During the break in period stay at or below 50% of the
running watt rating and vary the load occasionally to allow
stator windings to heat and cool. Adjusting the load will also
cause engine speed to vary and help seat piston rings. After
the 5 hour break-in period, change the oil.
The owners manual also describes preparation for short term, and long term storage. I see no mention of exercising the generator, every 30 days or so, like some folks do. Is this exercising done, due to not preparing for storage?
Jerry
The first 5 hours of run time are the break-in period for the
unit. During the break in period stay at or below 50% of the
running watt rating and vary the load occasionally to allow
stator windings to heat and cool. Adjusting the load will also
cause engine speed to vary and help seat piston rings. After
the 5 hour break-in period, change the oil.
The owners manual also describes preparation for short term, and long term storage. I see no mention of exercising the generator, every 30 days or so, like some folks do. Is this exercising done, due to not preparing for storage?
Jerry
