Salvo wrote:
Amusing!
There are quite a few people out there that are smarter than the PD EEs.
What's wrong with this picture?
After 240 min, the PD finally gets up to 14.4V. Current tapers from the get go.
14.8V spec
RJsfishin wrote:
If Voltage needed to be higher than 14,4, PD would have made it that way.
Are you all smarter than the PD engineers,....or just think you are.
Looks pretty good to me. I also use a PD9260.
Although I try to appreciate the various discussions about different charge voltages, for my layman needs I'm much more concerned about getting the proper charge current.
With my batteries discharged to 12.2v, my PD9260 produces almost 58 amps of initial charge current (measured using a clamp-on ammeter). It's rated at 60 amps. No complaints here.
