Headlight conversion
Anyone have any ideas on why I have no high beams when changing from seal beams to halogen? All wiring and connections on lamps are clean and tight, connector on light stalk is tight. This is on 1996 ...
Forum Discussion
Matt_Colie wrote:Jim-Linda wrote:
Single lamp each side, kit has housing that replaces sealed beam, H4 lamp, rubber cover for the original connector. Original connector and contact on H4 are the same, low beam works,
Jim
Jim,
This is interesting as the H4 lamp is the same connector as the 6012 you removed. I have run into cases where there were features of the OE connector that did not work with the composite headlamp assembly, but those were usually very obvious.
Matt
Connector is exactly the same, only change was to crank the Cat.
