Is this a bad circuit board? (fridge)
Its the type that uses the resistance probe. Which is all fine and dandy. I have not measured the ohms but assume its measuring accurately. Lets pretend the temp probe was hanging off the fins. Re...
Forum Discussion
I cant seem to trick my circuit board into 24/7 operation. Its a dometic with the temp probe only. No dial controls. I can leave the probe dangling in the wind and the graph will look the same with spikes every couple hours indicating the cooling cycle starting and stopping.
With a dangling probe, i should see air temp get down to say 35ish and stay there? Because the electric heater is still turned on for constant cooling? THe graph would not show the normal spikes. It would be more rounded with temp rising very slightly according to ambient temps.
Reason i ask is for super hot days when im opening the fridge a lot. Would be nice to just pull the probe off and let it danger during the heat of the day.
With a dangling probe, i should see air temp get down to say 35ish and stay there? Because the electric heater is still turned on for constant cooling? THe graph would not show the normal spikes. It would be more rounded with temp rising very slightly according to ambient temps.
Reason i ask is for super hot days when im opening the fridge a lot. Would be nice to just pull the probe off and let it danger during the heat of the day.
