Mounting solar on rubber roof
What's the best method in securing solar on a rubber roof trailer? This will be a flat install. Z-brackets are already ordered, but if there's something better... It is for my son-in-law's new to...
Forum Discussion
A stud finder will usually locate any fasteners that are in the plywood. That should indicate the rafter locations. I knew that my vent opening was located on the 16" spacing of the rafters so I measured back from that.
I have three parallel aluminum channels that are each attached across three rafters. Each channel has 3- SS 3", #12 screws. I also put a bead of Proflex sealant under each channel. The frame of the solar module is attached to the three aluminum channels with an intermediate aluminum angle piece.
I have three parallel aluminum channels that are each attached across three rafters. Each channel has 3- SS 3", #12 screws. I also put a bead of Proflex sealant under each channel. The frame of the solar module is attached to the three aluminum channels with an intermediate aluminum angle piece.
