My Solar Install
I have been meaning to post this for a while. I have been researching on this forum for at least a year now on what to do. Funny how this started as a way to top up my battery, to what it is now. T...
Forum Discussion
Few more shots
trying to figure out where it will go...
Sometimes you don't think that cutting wire would be complicating. I tried a couple of different way, but the sawzall with a metal cutting blade surprisingly did a good job- not pretty, but it worked
Next, crimping on the lugs
Didn't think I would have to use my wood vise and a hammer to bend the wire (probably should have shopped around more on the wiring). For some reason I am proud of this bent- slightly bigger gauge than before
one last picture of the board before going into the trailer.
I'll update next week with the pics after installing the Rogue. That controller in the pic could only handle one panel.
Still have lots of small finishing touches, but 80% there.
thanks for looking
trying to figure out where it will go...
Sometimes you don't think that cutting wire would be complicating. I tried a couple of different way, but the sawzall with a metal cutting blade surprisingly did a good job- not pretty, but it worked
Next, crimping on the lugs
Didn't think I would have to use my wood vise and a hammer to bend the wire (probably should have shopped around more on the wiring). For some reason I am proud of this bent- slightly bigger gauge than before
one last picture of the board before going into the trailer.
I'll update next week with the pics after installing the Rogue. That controller in the pic could only handle one panel.
Still have lots of small finishing touches, but 80% there.
thanks for looking
