Onan 3600lp turns propane regulator to red
My generator cut out last time I was out. That has never happened before. The 3600lp has always run flawlessly. I could start the generator up again but it would shut down after a few minutes. I n...
Forum Discussion
I read a lot more over the weekend. Had to do the glow plugs on my diesel, so I didn't spend much time on the generator. I borrowed good compression gauge from a friend because mine is pretty old and beat up. The compression test with his gauge read 150 lbs, so I know the engine is good. I wish I could find a rebuild kit for this demand regulator.
The test with the manometer between the demand regulator and the carburetor should measure a slightly negative pressure. This is due to the vacuum of the piston pulling the fuel in the the cylinder. I still haven't done that yet.
The test with the manometer between the demand regulator and the carburetor should measure a slightly negative pressure. This is due to the vacuum of the piston pulling the fuel in the the cylinder. I still haven't done that yet.
