Plumbing - parts and lingo question
I'm definitely a plumbing amateur. I've replaced a toilet and two faucets in my home, but nothing more complicated. Now I'm trying to install a bidet on to my Dometic 310 toilet. The unit fits ni...
Forum Discussion
Well, this has been a little adventure.
I've created...something. It might even work, but I'm going to give it a few days before I claim any sort of victory.
If this is art, it's more of a Picasso than a Rembrandt. :)
I'll post my solution once I'm sure of it.
5 of my 6 joints were working just fine, but I was having a very small leak at the water valve. Rereading this thread I wonder if this wasn't self induced. I put teflon tape on all the threaded pieces. I see the above comment about making sure I don't do this on the water valve. Was that just extra stupid? Am I likely to see better results without the teflon tape?
Anyway, fingers crossed on this one. It wasn't leaking when I tested it this afternoon. I'll leave it under pressure while we work on loading tomorrow.
Thanks again for all the feedback.
-B
I've created...something. It might even work, but I'm going to give it a few days before I claim any sort of victory.
If this is art, it's more of a Picasso than a Rembrandt. :)
I'll post my solution once I'm sure of it.
5 of my 6 joints were working just fine, but I was having a very small leak at the water valve. Rereading this thread I wonder if this wasn't self induced. I put teflon tape on all the threaded pieces. I see the above comment about making sure I don't do this on the water valve. Was that just extra stupid? Am I likely to see better results without the teflon tape?
Anyway, fingers crossed on this one. It wasn't leaking when I tested it this afternoon. I'll leave it under pressure while we work on loading tomorrow.
Thanks again for all the feedback.
-B
