Prosine 2.0 will not reset.
After 10 years of faithful service my Pro may be done. I have an error "Prosine internal error #xxxx" on the panel, then "attempting to restart".. but it will not. The inverter switch is on, and ...
Forum Discussion
msiminoff wrote:I had a look at where you showed in the pic, but it looks solid to me. Darn.
I discovered that one of the circuit boards had come un-seated from it's edge connector on the main board.
There's a black cover on the 120v side of the unit that looks pretty difficult to remove.. perhaps when I get more time I'll try getting that open. I also found some burned wiring on the 120v output wires. There's been a lot of amps passing through there. I don't know if those connections failed and then caused the internal error..
After removing the unit I bench-tested it with a small battery and nothing on the output side. Still internal error which will not clear itself.
