Help! Needed! Installing PD 4000
I'm installing the PD 4000 power center to replace an old Magnetek. The AC side looks straightforward I understand where I'm going to have to terminate everything. But the DC side I'm not quite unde...
Forum Discussion
ISBRAM wrote:
The fuses already on the board are for reverse battery protection and maximum load, if I understand your question you’re asking about the branch dc circuits.
There are twelve branch circuits running up and down in the center of the panel, the factory doesn’t install fuses in them so all you see are the terminals on the board that the fuses plug into.
There is a place to attach the wire to next to each fuse holding terminal pair for that circuit on the back of the board, then you have to install the proper size fuse for that circuit.
There is already a black wire connected to each branch fuse holder, and the fuses are easy. But let's take the pump as an example. There are two leads from the pump. If I connect say the black one to the wire already connected to one of the branch circuit terminal fuse leads what do I do with the other wire going to the pump. I do not see a common bus like those I see for the AC.
