Removing 50 Amp RV Surge Protector
If I was to cut the wire to install a Progressive Industries EMS-HW50C Hardwire 50 Amp RV Surge Protector in my trailer and then if I sell the trailer and want to remove it, would it be acceptable to ...
Forum Discussion
Bobbo wrote:djousma wrote:Bobbo wrote:
I used twist lock plug/sockets. Mine is 30 amp, but the principle is the same.
Bobbo, That doesnt look like heavy enough wire for 30amp? Looks from the photo like standard Romex wiring for 15amp circuit.
It is 10/2 w/g.
ON EDIT: I just went outside and photographed the cable sheathing. Here is the picture. It is hard to read, but says "AWG 10 CU 2 CDR WITH AWG 10 GROUND TYPE NM-B 600 VOLTS"
Looks like the same type of wringing my entire camper is wired with.
