Solar question
I just had a Renogy 400 watt solar premium eclipse Kit installed on our 2004 Montana 5th wheel. I had to have it installed because I recently had back surgery. I also had a Renogy 2000 watt inverter/c...
Forum Discussion
SW 3 (Power Saver):
The inverter’s power saver mode is activated when position 1 is selected. The inverter will detect a load for 250ms every 3
seconds and if a load is detected the inverter will start
outputting AC power.
NOTE:
If the switch position is set to 0 and power saver mode is
selected on the inverter main power switch, then no AC power will be outputted unless there is shore power connected to the inverter.
SW 5 (Battery/AC Priority):
When the inverter is set to battery priority (Position 1) it will invert power from the
battery bank to the AC outlets until the low voltage set point is reached. If there is an AC
source connected while under battery priority it will charge the battery after the low
voltage is reached and use the AC source to power the AC outlets. When the battery is
fully
charged,
the inverter will switch to battery power.
When choosing AC priority (Position 0) the battery power will Only be used when there is no shore power connected to the inverter. Once AC power is connected the inverter will start charging the battery bank
. If shore power is present for 15 continuous days,
then the inverter will use the battery bank for one cycle. This cycle is used to prolong
battery life. there is shore power connected to the inverter.
Setting priority, sets which power is the preferred mode AKA shore power, use battery only when necessary
set switch 3 to 1
set switch 5 to 0
