SOLVED: look at your Onan 4K genset for me?
EDIT: Never mind my request for you to report the orientation of the part described below. I now believe it does not matter. I will continue to update the thread re my troubleshooting findings. F...
Forum Discussion
Well, it's working. It was 2 marks too lean from the factory. In that condition, it binds and you have to pull on the rod to free it up. When it is set correctly, it does not bind. To be more exact, it binds lightly but pops free when the engine starts to crank. I have run it a few cycles now to be sure.
I did not guess it could be that simple.
Service manuals. Choose 981-530C.
Adjustment shown on page 8-12.
I did not guess it could be that simple.
Service manuals. Choose 981-530C.
Adjustment shown on page 8-12.
