Suggestions needed/changing dump valve seals
The dump valves were getting a little sticky and hard to operate at times so I figured I would just pull them off, inspect the seals, lube them up with vaseline and bolt them back up. Easier said than...
Forum Discussion
John Wayne wrote:
some one posted on this before and he used thin metal shims on each side of the valve as he slid it into place to hold everything together till it was lined up and then pulled the metal out.
That sounds like a plausible solution. While on this topic I wonder what the reccomended sealant for the tank inlet is. It has a clamp on it so I was thinking of using butyl tape. Any other ideas?
