MrRchitty wrote:
Hybridhunter wrote:
mdelleman wrote:
I tried starting the skill saw (14A) and it overloads almost right away. I can get the saw to spin a little without overload but once it really gets going almost instant overload.
Tried my 2HP air compressor as well and that goes out instantly. Hardly sounds like the compressor tried.
That's the thing that bothered me most, they don't load up, the extra 150ms on the newer modules helps with certain loads, but for the most part, is still vary disappointing.
I am going to say it is 150ms.
Go online and check out supergen.com
Talked to someone at SuperGenProducts. Very helpful. Offered to do the software upgrade for free as long as I take care of postage both ways.
I am in Canada so postage won't be cheap so I may try Champion first and see what they can do for me...
