MrRchitty wrote:
Hybridhunter wrote:
mdelleman wrote:
I tried starting the skill saw (14A) and it overloads almost right away. I can get the saw to spin a little without overload but once it really gets going almost instant overload.
Tried my 2HP air compressor as well and that goes out instantly. Hardly sounds like the compressor tried.
That's the thing that bothered me most, they don't load up, the extra 150ms on the newer modules helps with certain loads, but for the most part, is still vary disappointing.
I am going to say it is 150ms.
Go online and check out supergen.com
I wasted my time to upgrade the modules with ones fresh from supergen, and the delay with getting the new modules shipped was epic. We did them on an exchange basis, and it was a total waste of time. It still would not run a WFCO 8955, which has not one spec outside the CPE 200i's range.
