Water pump switch question
I am in the process of installing the SeeLevel tank monitering system. I bought the monitor that has the water pump switch and the water heater switch. My current system uses an Intellitec Mpx Low S...
Forum Discussion
Dusty R wrote:
/Users/davidrhodes/Pictures/Photos Library.photoslibrary/Thumbnails/2019/02/22/20190222-122231/jKzgMIIhTgOnA4h9uUQzIA/thumb_DSCF3877_1024.jpg
Not good at posting pictures. If someone could open this picture it would be great.
My panel is 6-1/4" x 8-3/8" tall.
The generator control and hour meter is in the top 2-5/8" and the tank monitor is in the bottom part, which I cut off, then cut a new plate the same size that I cut off. Then I cut a hole in the new plate just smaller than the size of the control panel from Garnet, and mounted it in that hole.
The pump and water heater control switches are in the panel that I got from Garnet.
Good Luck,
Dusty
That picture is on your hard drive. You can't link to one on your computer, you have to post it to a server somewhere then link to it there. Go to this link, drag and drop the picture, it will give you a link. Post THAT link here.
http://photoposting.is-great.net/?i=2
