WFCO WF-8955 amps in absorption mode
I have a WFCO-8955 (55 amp) that absolutely will not go into bulk mode even though it’s a 3 stage converter. Not sure if it’s inadequate wiring or an inadequate converter. It’s always 13.6-13.8 no mat...
Forum Discussion
Good responses above.
I never got far enough to figure out if it was a wiring deficiency or just the normal behavior (which apparently can be tricked into working better), as we didn’t use the camper a lot and always had power either with hookups or the generator.
But had I kept the camper, I would have looked into the above suggestions and/or junked it for a better converter.
I had the same issue as the OP. It never went into full charge mode. Never saw more than 13.6V at the batteries.
I never got far enough to figure out if it was a wiring deficiency or just the normal behavior (which apparently can be tricked into working better), as we didn’t use the camper a lot and always had power either with hookups or the generator.
But had I kept the camper, I would have looked into the above suggestions and/or junked it for a better converter.
I had the same issue as the OP. It never went into full charge mode. Never saw more than 13.6V at the batteries.
