Show your mods!!
This is a removeable DVD stand I made out of conduit and wood for the back bunk in our Jayco 23B. swivels and tilted slightly. I also made one that will slide in the post where our regular TV sits for...
Forum Discussion
Here's a few more I just did this week:
After trying to back into a dark camp site I decided to add some back up lights to our Roo. I considered tying them into the truck’s backup light circuit but decided to run them separately so in case we wanted light back there without being hooked up we could. I used some fog lights I picked up at Walmart.
While I was in the light addition mode I also added a Blue LED bar (again from Walmart) and installed it above the steps. I think I’ll add some reflective tape to the edges to really help see them in the dark.
Here are the switches that control both the step LED and the backup lights
When I pulled the step out it had about a half a cup of water pooled in it… So I drilled some drainage holes. Looks like I need to add some more paint around the one hole.
After trying to back into a dark camp site I decided to add some back up lights to our Roo. I considered tying them into the truck’s backup light circuit but decided to run them separately so in case we wanted light back there without being hooked up we could. I used some fog lights I picked up at Walmart.
While I was in the light addition mode I also added a Blue LED bar (again from Walmart) and installed it above the steps. I think I’ll add some reflective tape to the edges to really help see them in the dark.
Here are the switches that control both the step LED and the backup lights
When I pulled the step out it had about a half a cup of water pooled in it… So I drilled some drainage holes. Looks like I need to add some more paint around the one hole.
