12 volt system problem

ahHAH!! Learning never ends.

The converter will put out theoretically 35 amps, so if wire is larger then #10 you could use 30 ampere fuses.

Converter info: WFCO. Model # 8735/8470

Again, to all who have replied: THANK YOU!! I’ve learned so much. Always been a tent camper until purchasing this unit last year so this electric stuff is a little more advanced that tent poles. LOL I hope this discussion helps others or gives them courage to try. Let me know if I need to be aware of anything with the converter.

If you're trailer sits disconnected from shore power for more than a day or two then you should have the battery disconnected. Some people pull the negative cable off the battery in storage. Some people pull the fuse by the battery. And some people add a disconnect switch on the battery. All three do the same thing of stopping the battery from being discharged by phantom loads while in storage.

Make sure to hook the battery back up before you tow to make sure the emergency breakaway switch has power in case the trailer becomes disconnected while towing.

A manual battery disconnect on the battery would be beneficial for when rig is in storage.
Suggest carrying extra fuses.
What is size of the converter? Make and exact model hould help. Check size of wire between battery and 12 volt distribution panel. May be good to increase size of fuse if wire is large enough. #10 or larger! Verify that the fuse holder is tight. A loose connection could cause overload.

Found 20amp fuse blown on distribution panel ! Looking good now. I never did see any type of battery disconnect or circuit breaker...just another 20amp fuse near battery which was good.

Is a battery disconnect something I should invest in? This is quite the basic Ranger 10 which is exactly what I wanted. But sometimes an extra add-on is most helpful. Thoughts???

BIG THANK YOU!!!

Make sure you didn't reinstall the battery reversed. If you did there will hopefully be blow fuses that protected things.

Had the same problem this week when getting the camper ready for the season, had a blown inline fuse.
Mine is located by the battery, changed out fuse, all is good. Good Luck.

Switch on some look like a standard house type switch.
Look for a junction box or terminal strip where the umbilical or from TV connects to the trailers wiring system. There is commonly a circuit breaker at that location.

If you have a battery disconnect switch, make sure it is turned on. What you describe is how mine functions when the battery disconnect switch is off.