7 way power cord

Jeff,

I assume this is what you are referring too. Dont know if they are considered weatherproof but they are factory terminated so they may be better. Never had trouble with mine over about 7 years or so.



http://www.reese-hitches.com/products/7_Way_5th_Wheel___Gooseneck_Trailer_Extension,118664

The second photo posted by RoyB above is my truck :) . I made my own. It cost me $22.00.

It's not necessarily as simple as buying a cord with two male ends.

Palomino, for example, uses a different wiring scheme on the camper-side plug. I had to spend a couple hours with a 12V battery pack and some probes to figure out which pin went to which light on mine.

There is absolutely nothing wrong with the "screw on" plug ends. They are very well designed to keep the weather out.

If you're paranoid, just take the umbilical off and put it in the cab of the truck while the rig is parked for long term.

mkirsch wrote:
It's not necessarily as simple as buying a cord with two male ends.

Palomino, for example, uses a different wiring scheme on the camper-side plug. I had to spend a couple hours with a 12V battery pack and some probes to figure out which pin went to which light on mine.

There is absolutely nothing wrong with the "screw on" plug ends. They are very well designed to keep the weather out.

If you're paranoid, just take the umbilical off and put it in the cab of the truck while the rig is parked for long term.

Jeff's comment:

Male on both ends is easy to find but this one is female on one end and male on the other end.

I cant imagine why a cord would be designed with a male on both ends. Perhaps its the female connector that looks like a male due to the housing but it is truly a female.

My suspicion is Jeff needs a standard cord. Not sure about how/why Palomino would be any different. Not saying they aren't but doesn't make any sense.

wittmeba wrote:

I cant imagine why a cord would be designed with a male on both ends. Perhaps its the female connector that looks like a male due to the housing but it is truly a female.

My suspicion is Jeff needs a standard cord. Not sure about how/why Palomino would be any different. Not saying they aren't but doesn't make any sense.

If the camper doesnt have an umbilcal cord it would terminate with a female plug, hence needed male/male-But he did indeed say need an extension cord male x female.

Ive never looked at the plug on a truck camper but why wouldn't the camper be designed to "plug-in" to the line like any other rv? 50 amp service does not use 2 male plugs but typically have a form of plug on both ends. That seems why the extension posted will work. Just thinking this is the example of the female receptacle that looks like a male plug but isn't. Male-male could be dangerous if it has exposed pins and dropped it on the metal truck bed.

Example - this to me :) is a male-female.



This page:

http://www.etrailer.com/Accessories-and-Parts/Blue-Ox/BX88206.html?feed=npn&gclid=CKu2vfap-rkCFfA7MgodKhEAGg
does show a yellow female-female but have no idea where it might be used.

This is all new to me. Im just trying to learn.

Here are the two ends. I called one of them female.
So this is the cord I need.
Thanks.

I think I too said male when in fact it is a female, however the molded rubber portion goes into a socket therfore it is more of a transvestite type of plug, it could go either way, depending how you look at it. I think what royb refers to is a boat twistlock type connection that is used in the marine industry. You install the plug and give it a 1/8 twist or so to lock into socket. This was designed to keep the dock connect from getting kicked into the water when the drunk boaters stagger home after a night at the yacht club.

Jeffoxsr:
Your picture shows two male connectors
The receptacle on the vehicle is a female and one of your cable ends must plug into it. The camper should also have a female receptacle.
Best solution is to buy a long 5er or TT replacement cable with one end made up and buy a separate male cable connector and install it your self.

jefffoxsr wrote:
Here are the two ends. I called one of them female.

Hard to tell...and sometimes hard to tell in real life :B

Those are two different versions of the same MALE connector.

The one with double-contacts (what you probably call "female" is the more expensive/better version. The other is the cheaper version.

Yes, my Palomino and others I've seen, use a male-to-male "patch" or "umbilical" cord. Lance has their own proprietary connector on the camper end, at least in some years.

On the left front corner of my Palomino is a standard POLLACK 7-pin female connector, same as what you install on your truck.

The wiring is non-standard for the lights and whatnot. Why? I don't know. It is not documented in the owner's manual either.

When I picked the camper up, I thought it would be a simple matter to get tail and turn signals for the ride home. The ground is the same, and the right turn signal is the same.