Bearing packing drama
I bought my camper new last year. After a couple of trips i noticed the hubs on the drivers side were getting so hot that i could not hold my hand on them. The passenger side hubs were warm but much c...
Forum Discussion
Walaby wrote:
Given the choice of a tiny turn more than finger tight, or a loosening, I have always leaned toward a tiny turn tighter. Yes, if you over tighten, you will increase risk of overheating the bearing, but to tighten essentially the width of one "castle" on the castle nut past finger tight would be just fine and would be a lot better than the bearing being slightly loose.
Mike
Bad information, slightly loose is what you want.
