Bike rack for truck

I made my own "bike tights" at work and mounted them staggered on a 2x6 that lays in the bed of the truck. Staggering lets you mount the bikes close together without the handle bars and seats touching each other. I have two bikes on each side of the bed leaving the center open for other gear and the front wheels go between bikes and bed of truck.

Love this:

http://www.autoanything.com/shop/SportsRack-Truck-Bed-Bike-Rack

And with the pvc rack you can take it out of your truck at the camp site and use it there. Helps keep some of the bikes off the ground.

I made one like this.
http://www.utahmountainbiking.com/goodies/TruckbedBikeRack.htm
I put 2 Ts on the bottom of the stand and jam the T's into two of the holes for the table legs in the toy hauler. A couple straps later and I'm off.

I don't have one of these yet, but it is on my "wish list". It says is will hold 6 bikes. I hope the link works, if not search for softride Shuttle Pad.
Softride Shuttle Pad

You can buy a truck pad (http://www.dakine.com/p/bike/pick-up-pads/pick-up-pad---large?clr=002)and hang the wheels over the tailgate. I squeeze 5 bikes in the truck bed of my lil Tacoma. If you need a picture of it to understand, check this link out: http://forums.mtbr.com/car-biker/dakine-pick-up-pad-764620.html And if you don't want to buy a $100 truck pad, you can use a thick blanket to protect the tailgate.

I built one out of pvc pipe, cost about 15 bucks !! Just google pvc bike rack and see if you could modify it for your situation !! Good Luck

Lantley, did you purchase that rack or make it? Sounds like a good idea. Oops - sorry. Should have visited the sites first. :S

You may want to try a tongue mounted rack. I believe they are the best solution. No need to drag dirty bikes inside. No need to disassemble bikes. Bikes are always safely in view. There is no bouncing.
I am currently using the same rack with my 5'er.
Photo of my old TT setup below



Lots of Arvika Bike rack photos

Arvika web site