GFI not working-blew 2 30 amp service fuses

looking back at your original post and the additional information that your posted about the generator in the system, since you blew TWO 30 amp fuses, it is possible that you caused a significant issue with your generator depending on its size and on board protection. You might look closer at its output / setup without anything attached other than a "test load" (lamp / light).

water got in your converter and fried it now its a direct short to ground unplug or unwire it things will work again

Since you replaced the outlet, and now the generator breaker trips, I bet those two are connected. The outlet is probably miswired.

....when I try to plug anything in, it flips the generator breaker

This would typically indicate that there is something 120V that is miswired.

pattycamper wrote:
I have a meter, but all I have tested with it is batteries :( I will google how to test breaker. I flipped all breakers back and forth, so I don't think they are issue as far as not being reset. Fuses aren't blowing anymore, just first time issue started. When I was trouble shooting last time, it was after 3 day trip and camper was in street with no AC in 110 degrees. I had to stop because I was about to pass out. I'm not certain if any AC is working at this point. If I remember correct, by the time the generator breaker started flipping after replacing GFI, NONE of the plugs, GFI or otherwise worked. Initially my other non-gfi outlets were working. I could have been a bit delusional at the end of this before I put it in storage :) I will test breakers as soon as I can get back to trailer. I recently replaced the 30amp breaker (it dry rotted apart) that the battery lines go through at front of trailer where battery connects. Any chance this could be part of issue. It was working, but maybe it blew?
Patty

the "30 amp battery breaker" is unlikely to be your issue since it only deals with the 12v system although it depends on whether you have any 12v controllers / relays needing power to operate them.
As you surmise, check if any of the AC circuits are working (either with a meter or light or operating equipment). The key check is to find out if you are indeed getting 110v into the breaker.... having said that, you added some more information with the "generator breaker part" so you might have to look at that portion of your setup.

gmw photos wrote:
Personally I hate it when folks come on to these forums and suggest rookies grab a multimeter and start poking around. Truth is, do it wrong and you can die from electrocution.

If someone is going to suggest to another to get a multimeter, the first thing they should suggest is the new person get instructions on the safe use of it from a qualified individual.

Electricity is infinitely patient.....just waiting for you to screw up so it can bite you.

that's funny. Me too, to have to even suggest that someone working with electricity, if they desire, would use a tool to help themselves find out what's going on.

If a lot of water entered a GFCI protected outlet there could still be moisture. Does not take much.

Usually the A/C is on a separate non-GFCI circuit so it would seem odd that the tripped GFCI would affect the air.

Assuming you have a 30 amp RV there should be only one 120v 30 amp breaker. If two 30 amp fuses opened that sounds like the main or reverse polarity fuses for the converter 12 volt system. Again seems odd the GFCI would cause an issue here. Was any battery work done? Do you have about 13.6 volts on the battery when plugged in?

The A/C thermostat does need solid 12v power to operate the A/C.

I have a meter, but all I have tested with it is batteries :( I will google how to test breaker. I flipped all breakers back and forth, so I don't think they are issue as far as not being reset. Fuses aren't blowing anymore, just first time issue started. When I was trouble shooting last time, it was after 3 day trip and camper was in street with no AC in 110 degrees. I had to stop because I was about to pass out. I'm not certain if any AC is working at this point. If I remember correct, by the time the generator breaker started flipping after replacing GFI, NONE of the plugs, GFI or otherwise worked. Initially my other non-gfi outlets were working. I could have been a bit delusional at the end of this before I put it in storage :) I will test breakers as soon as I can get back to trailer. I recently replaced the 30amp breaker (it dry rotted apart) that the battery lines go through at front of trailer where battery connects. Any chance this could be part of issue. It was working, but maybe it blew?
Patty

Fuses are normally for the 12 volt DC system
120 Volt AC is normally controlled by standard circuit breakers.
Try resetting circuit breakers. Turn them off applying light pressure toward off, then turn on main breaker if equipped, followed by branch breakers one at a time.

Personally I hate it when folks come on to these forums and suggest rookies grab a multimeter and start poking around. Truth is, do it wrong and you can die from electrocution.

If someone is going to suggest to another to get a multimeter, the first thing they should suggest is the new person get instructions on the safe use of it from a qualified individual.

Electricity is infinitely patient.....just waiting for you to screw up so it can bite you.