Lost the Truck Camper...

My son sent me a picture with the truck still there..It appears he had tie downs with the chains dangling down...Hummm..I wonder what really happened..

d3500ram wrote:
...... JB weld and she'll be good as new!

Will need the 5-minute JB Weld since its blocking traffic.

Will not be anything left after wrecker driver wraps 1/2 inch cable around it and drages it onto flat bed wrecker.

That's got to be embarrassing. Can you reload that back on the truck once it's down like that?

It really is time they remove the "Eject" button from radio dash. People misuse it all the time.

Some duct tape and JB weld and she'll be good as new!

There is another possibility and that is it was being transported on a trailer and slid off. I still cringe with any scenario.

Kayteg1 wrote:
Plastic bedliner and weak ties can do that when you drive 400 HP monster.
I am always skeptic looking at fastgun hooks when I set my 6000 lb camper.
So far had it on 12% grades and it did not slide out, but I am religious about putting rubber mat under.

I have Fastguns and have traveled up and down a 19% grade with no problems. The 19% grade is on Deadmans Bar Road which is on the east side of Teton National Park on US Hwy 191 at mile marker 175.75. I would include pictures if it wasn't so difficult on this forum.

Try this, it might get you to the pictures:19% Grade and Deadmans Bar River Road signs. It is Reply number 119.

LeRoy

It's not "lost" I'm sure he remembers exactly where he left it. ;)

I don't know how you could miss the rear end popping up as 2500lb falls off the back.

That gives a new definition to the term "slide out". :)