OUCH!... I hate when that happens (:
I am always so careful about lining up and backing inthe truck... got a little too close this time. The stud on the tailgate opening jamb was a little too close and I peeled back the metal skin on a ...
Forum Discussion
Yea, it was pretty easy. Having a pre-bent metal piece was the big factor in a decent patch. If I had to brake the metal then that would have been a different story and perhaps not as clean.
I will trim the buytl and then pooky some sealant on the edges later this week.
I will trim the buytl and then pooky some sealant on the edges later this week.
