OUCH!... I hate when that happens (:
I am always so careful about lining up and backing inthe truck... got a little too close this time. The stud on the tailgate opening jamb was a little too close and I peeled back the metal skin on a ...
Forum Discussion
I added some strips of ptf or hdpe(cutting board) to our bump out.
Though the tailgate pin is flush to the pillar and havent hit (yet), if not perfectly square I'm agasint pillar pretty hard if I blink.
Inside at the top of bumpout is bottom of our shower and access to its P-trap thru panel, the black tank is at bottom.
Though the tailgate pin is flush to the pillar and havent hit (yet), if not perfectly square I'm agasint pillar pretty hard if I blink.
Inside at the top of bumpout is bottom of our shower and access to its P-trap thru panel, the black tank is at bottom.
