Pressure Tested Camper Leaks Found
Set up a leaf blower to pressurize the camper. Went around the whole thing with soapy water. Four leaks along the corner moulding. Removed the insert trim and screws along the bottom side and co...
Forum Discussion
I Think the OP used a leaf blower and I think the CFM will be quite a bit higher than a Vacuum.
And as you stated, maybe it's an internal issue?
And as you stated, maybe it's an internal issue?
ticki2 wrote:
Jim , perhaps I am overly optimistic of the test and thought it would show up any leaks . I am half wondering now if it is not a condensation issue under certain conditions . My camper is riveted aluminum skin , aluminum ribs and aluminum interior skin with factory spayed on foam insulation . But if that were the case , being the camper is now 49 years old , the wood wings should have rotted out long ago .
