TC Ladder Parts
Some of my ladder end caps are cracked. They are black plastic and some are starting to crack. Does anyone know where to get those? I also advise that you change out the rust prone screws over to s...
Forum Discussion
By the time my tread endcap screws started showing rust, it turned out the tube coupling nuts "wings" had rusted away so that the ladder standoffs were loose, so I replaced them in both the standoff and the attachment plates for the ladder
You can get the tubing coupling nuts at McMaster Carr, if you can't find them at the hardware store.
The standoffs on mine used 1/4"-20 Panhead machine screws, while the mount plates used 1/4"-20 Flathead machine screws.
Installing new coupling nuts, using a socket and tapping into the 1" ladder tubing with a hammer to the desired depth (shown below) was much easier than removing them :D
You can get the tubing coupling nuts at McMaster Carr, if you can't find them at the hardware store.
The standoffs on mine used 1/4"-20 Panhead machine screws, while the mount plates used 1/4"-20 Flathead machine screws.
Installing new coupling nuts, using a socket and tapping into the 1" ladder tubing with a hammer to the desired depth (shown below) was much easier than removing them :D
