Torklift Cannon
(Mod Edit: Link to original article to give the author - Mello Mike - credit)
Article
Looks like a problem solver for newer Fords.
Bob
Article
Looks like a problem solver for newer Fords.
Bob
Forum Discussion
Kayteg1 wrote:
Shall I sue for copyrights?
George Foreman is ready to take yo money when you are. :)
bradwKayteg1 wrote:
Shall I sue for copyrights?
You might not like the result if you tried. Torklift probably prototyped something similar years ago. :DKayteg1 wrote:
I build that almost 2 years ago.
Cost of 48" of 3" tubing about $40, including cutting.
That was my plan, but after taking a good close look at the factory receiver hitch, I wasn't confident that it was robust enough for 7,000 lbs on a 4' extension. 7,000 lbs on 2' or 3,500 lbs on 4' seemed OK. It cost a lot more to go with the 30k lb Torklift receiver, but I'm glad I did.
bradw- Too bad it's only 3600/360 and without WD for the 36".
- I build that almost 2 years ago.
Cost of 48" of 3" tubing about $40, including cutting.
Shall I sue for copyrights?
