Truck Leaning 1" - Super Springs

Is your camper loaded in the middle of your bed, or off to one side?

It is in mid and if anything a little more to the opposite side of the lean. So that is not the problem.

Hmm. I'm guessing there is some weight difference in how things are loaded/built in the camper. From my limited experience, I think of helper springs as raising the back end of the rig up. I need to tighten mine to lift the rear of my current setup with a heavier camper.

Yeah, I am hoping increasing the tension will negate that 1" sag from the unbalanced camper probably due to propane tanks, fridge, microwave, tv etc etc all on that side.

I would just add some tension to the one side if you can.

jimh425 wrote:
I would just add some tension to the one side if you can.

Would that effect the truck when the camper is off? And if it is too much when it is on and leans right lol Oh my shoulda got air bags...

I don’t think SuperSprings are supposed to impact unloaded ride. You might try giving them a call/email.

Can you move weight to the other side?

Assuming there is nothing wrong with the suspension, it implies you have more weight on one side...shifting some back will level it out.

If you adjust the springs, yes, it will leave that side high when unloaded. I suppose if you had airbags with integrated control, you could change it on the fly but better to even the load out if possible.

There is nothing I can shift.

I don’t know how much each adjustment hole changes the force, but my guess is a few hundred lbs. I think I’d try the next higher setting on the side that is low. There are 4 shackle settings from low to max according to their website.