AnEv942 wrote:
Steam and pre bend?
Yes, thinking about it...but I am going to try kerfing today on a scrap section to see what it might look like. I really don't want to have to build a 4'x8' steam box just for these 4 remaining pieces. Also I worry that the plywood would swell and warp in other ways.
But steam and pre-bend is definately on the table. I could also go with three or four layers of 3mm instead of the two layers of 5mm...but the 3mm is $57 a sheet and I already have a lot of the 5mm from an old project.
Cross fingers on kerfing...I will post results soon.
