12v led wiring
I'm trying to figure out how to wire a led strip inside my pass through compartment that has a push button to turn on the light when you open either door.Do I need to run wires from one side to the ot...
Forum Discussion
Run 12VDC (+) to the hot side of your LED strip. Then run two wires from the negative side of the LED strip; one to each push-button switch. The other side of each switch will be attached to ground (-).
Or you can reverse that; run 12VDC (+) through each switch to the hot side of your LED strip, and attach the negative side of the LED to ground. It's really not rocket science.
Or you can reverse that; run 12VDC (+) through each switch to the hot side of your LED strip, and attach the negative side of the LED to ground. It's really not rocket science.
