Equal bearing for both sides of landing gear?
My first 5th wheel had separate controls for the landing gear so this was never an issue but my new one is just one switch. How concerned do I need to be about getting both sides of the landing gear ...
Forum Discussion
Old-Biscuit wrote:
For 7 yrs. we set up/torn down our 5vr weekly.
I ran driven legs down from travel position a couple of inches then pulled the snap pins letting inner leg fall to ground (12X12 plastic 1/2" cutting boards under each leg)
Then would run driven legs down letting the pins snap into holes when they lined up and start lifting 5vr.
For me it was K.I.S.S.
This is exactly how I do it. Never a problem
