Landing gear/ Gear box replacement
Replacing Lippert part made by Venture. Its the gearbox at top of a single leg motor for the landing gear. One of plastic tabs broke off and gearbox is moving around quite a bit while extending and re...
Forum Discussion
Thanks for the help and suggestions. I did put jackstands under frame just in case, but did not need them.
I did have to use the manual turning rod to align with the spline on the motor shaft. All in all it was easy switch.
I don't understand why the factory used a plastic case instead of the aluminum one I replaced it with, I guess it has to do with cost.
I did have to use the manual turning rod to align with the spline on the motor shaft. All in all it was easy switch.
I don't understand why the factory used a plastic case instead of the aluminum one I replaced it with, I guess it has to do with cost.
