Raising a 5er

Also, check out that post by wuhungsix. Lots of good information--you may decide to look for a sub-frame shop before starting the correct track.

Search out my post on correct track before starting the installation. Also, it would be a good idea to back the trailer up on boards until it sits the way you want it. Then, you'll know exactly how many inches that you need. Also search on jacking up the trailer. If it falls on you, you're dead.

I decided to go with the correct tract that I bought from amazon they say in the video it will raise the coach up the 2ins.My axles are on the bottom of the springs. Thanks.

If your axles are mounted above the springs an axle flip will give you almost 7 inches of lift. If they are already under the springs a subframe is the only safe way to go.

I did a 6" sub-frame lift. I love it. With the suggestion of members here I had my fabricator add extra holes in the new shackles too in case I ever needed further adjustment.

http://www.rv.net/forum/index.cfm/fuseaction/thread/tid/28055166.cfm

JIMNLIN wrote:


Most folks use a square tube sub frame between the main frame and suspension to raise the trailer safely.

Some trailers have have pre-drilled mounting holes to raise the trailer on the suspension - Jayco calls it "Jake Plates".

If not, JIMLIN's suggestion is the best option.

A few years ago, there was a poster who did that (himself) and had lots of photos of the project.

You might search the archives.

.

Poppy's 5th Wheel wrote:

routemaster wrote:
What is the distance supposed to be from top of bed rail to the overhang please?

Most say 6".

Today I dropped the king pin by a 1ins then lifted the hitch up 1ins now I have the 6ins, but now the nose is high. Now I have to decide how I will raise the rear end.

routemaster wrote:
I don't have any extra holes in the hangers. I have thought about the Correct Track they say that can lift by 2ins?
Also no chance to flip the axle thanks.

My thread about lift I did

I did a 1.5" lift with the Mor/Ryde x-factor. If you read through all 4 pages of this thread, you'll see the discussion about the x-factor cross-member brace. You can add up to 3 of these, I think. The manufacturer of my 5th wheel had to do a recall on a similar 5th wheel and Mor/Ryde designed the lift and included 1 x-factor. So, I copied that solution for my lift.

The Correct Track is another route to go and can get you to 2". I probably would have been better off with 2" or more. I think I got 1.5"-1.75" max on the lift I did. A little more would have been better, but I'm happy with what I ended up with.

routemaster wrote:
What is the distance supposed to be from top of bed rail to the overhang please?

Most say 6".

What is the distance supposed to be from top of bed rail to the overhang please?