Remove Dinette and Install table & chairs
We have a 2011 Jayco Recon and we would like to replace the U-Shaped dinette with a free standing table and chairs. It doesn't look to difficult to remove the seating section but the question I have...
Forum Discussion
We had a table in our Raptor, it appeared to be screwed down the the floor. My guess is that with the side extended you can run a bolt through the leg of the table and through the slide out floor. I'd think there is enough room for a fender washer and nut to secure the table. However you'll need to explore your setup Our chairs had a simple hook located on either side of the chairs that had a strap that hooked in place and was then tightened by pulling on the strap. Worked fine, unless we forgot to secure the chairs. ;)
